Slime 50139 Manual

Overview

* VALVE DEPRESSOR IS TO BE USED WITH ACCESSORY ADAPTERS

Slime® provides a quick emergency repair. Treated tires should be repaired by a qualified tire professional at the earliest opportunity to ensure safety and proper cleaning of tire pressure sensor, if so equipped. We recommend treated tire be repaired within 3 days or 100 miles after use of Slime Tire Sealant, whichever comes first. Advise tire professional of product use.

ATTENTION! READ ALL INSTRUCTIONS CAREFULLY FAILURE TO FOLLOW WARNING INSTRUCTIONS CAN RESULT IN FIRE, PERSONAL INJURY OR PROPERTY DAMAGE.

HOT

• DO NOT HOLD IN HAND WHILE OPERATING
• PLACE INFLATOR ON A HARD, CLEAN SURFACE.

1. DO NOT run vehicle while inflator is operating. You may need to be in "accessory" or "on" position. Please make sure emergency brake is set and car is in park. Always ensure the valve connector is fully seated to depress the core of the valve stem for proper inflation.
2. DO NOT use inflator continuously for more than 15 minutes. Allow unit to cool approximately 25 minutes between uses. Do not leave inflator unattended.
3. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
4. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful not to inflate items beyond their capacity.
5. While operating, never block the inflator input or output.
6. Keep inflator out of reach of children.
7. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp cigarette lighter receptacles.

AIR ONLY INSTRUCTIONS

Check your tire warranty prior to installation of this product.
The AIR ONLY mode can also be used for bicycles, sports balls, rafts and other inflatables.

1. Select AIR ONLY.
   NOTE: Lay Flat Tire Repair Kit on the ground facing upward.
   
   
2. Screw air/sealant hose onto tire's valve stem.
   
3. Plug inflator into 12 volt accessory power outlet. Do not run vehicle while inflator is operating. You may need to be in "accessory" or "on" position. Please make sure emergency brake is set and car is in park.
   
4. Push green button to turn system on. Fill to desired pressure. Turn system off and check tire pressure. Once correct tire pressure has been achieved, disconnect air hose and power plug.
   

When using the supplied inflatable adapters, the valve depressor adapter (Fig. X) must be used in conjunction with the inflatable adapters. Failure to use the supplied valve depressor adapter with inflatable adapters will result in over-pressurization and failure of the Flat Tire Repair Kit. To install, remove the valve depressor adapter assembly from the back of the Flat Tire Repair Kit. Unscrew the Presta valve adapter and set aside. Thread the valve depressor adapter into the air hose of the Flat Tire Repair Kit (Fig. Y) until fully seated. Thread on the desired inflatable adapter until snug and inflate item.

FLAT TIRE REPAIR (AIR + SEALANT) INSTRUCTIONS

Check your tire warranty prior to installation of this product.
NOTE: Seals punctures up to 1/4in. (6mm) in tread area for flat tire repair.
Correct tire pressure can be found in your vehicle's owner's manual or driver side doorjamb.

1. Select AIR + SEALANT.
   NOTE: Lay Flat Tire Repair Kit on the ground facing upward.
   
   
2. Screw air/sealant hose onto tire's valve stem.
   
3. Plug inflator into 12 volt accessory power outlet. Do not run vehicle while inflator is operating. You may need to be in "accessory" or "on" position. Please make sure emergency brake is set and car is in park.
   
4. Push green button to turn system on. Gauge pressure will initially be high until the sealant bottle is emptied. Once bottle is empty the gauge pressure will drop and tire inflation begins. Fill to desired pressure. Turn system off and check tire pressure. Once correct tire pressure has been achieved, disconnect air hose and power plug.
   

Drive two miles with speeds less than 25 miles per hour to disperse sealant throughout the tire, allowing it to seek out and seal the puncture. Recheck tire pressure to verify that the puncture has been sealed.
At your earliest opportunity take your vehicle to a tire repair facility for a permanent professional repair. Inform tire repair specialist that Slime Sealant is in the tire.

PRESSURE RELEASE The PRESSURE RELEASE ensures optimum PSI pressure. Push the area to deflate the tire if it has been overinflated, or if there is too much air prior to inflation. Check your gauge for the desired PSI level. NOTE: Correct tire pressure can be found in your vehicle's owner's manual or driver side doorjamb.

SEALANT CARTRIDGE REMOVAL INSTRUCTIONS

TROUBLESHOOTING

Inflator fails to operate when plugged in

1. Check fuse in power cord.
2. Check vehicle fuse.
3. Check vehicle's battery charge.
4. Ensure connection is secure.
5. Check receptacle and plug terminals for dirt (particularly tobacco). Use a non-conductive probe (not fingers or metal) to dislodge and remove debris.

Inflator runs but does not inflate

1. Be sure the connector is tightly screwed on the valve stem as far as possible.
2. Check tire for leaks, and check hose for breaks and leaks at fittings.

Inflator runs slowly

1. If overheated from excessive use, shut it off and allow to cool for 25 minutes.
2. Voltage too low, check condition of vehicle's battery.
   NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to leak out when trying to inflate. In the event this situation occurs, you will have to jack up the tire prior to inflation.

IRRITANT TO SKIN AND EYES. MAY CAUSE ALLERGIC SKIN REACTION. Avoid ingestion. Avoid eye and skin contact. Wash hands after use. Use only as directed. KEEP OUT OF REACH OF CHILDREN.
FIRST AID: In case of eye contact, rinse eyes for 15 minutes with cool water, lifting eyelids occasionally. If on skin, wash with soap and water. If inhaled, seek fresh air. If ingested, DO NOT INDUCE VOMITING; drink plenty of water and contact a physician or hospital. Contains Glycerol, Natural latex rubber, Water, Ethoxylated isotridecanol, Poly (dicyclopentadiene-co-p-cresol).
Call ChemTel: +1-800-255-3924 or 1-813-248-0573
Reference product name: PART#50139 or #10189 (Refill)
Sealant cartridge refills available

QUESTIONS OR COMMENTS: Call 1-888-457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA