Installing Cf Card; Removing Cf Card - 3Com MSR 50-40 ROUTER. Installation Manual

Installing CF Card

Figure 6-10 Press the CF card into the slot
Install the CF card following these steps:
Step 1: Push the spring button into the slot completely, and make sure it only springs out with outside
force.
Step 2: Press the CF card into the slot in correct orientation, and make sure it only springs out with
outside force.
Make sure the CF card with correct application program is properly installed in the slot; or, the system
cannot boot.

Removing CF Card

Remove the CF card following these steps:
Step 1: Check the CF card LED to make sure it is not blinking, and then proceed.
Step 2: Press the spring button to release the internal spring clip, making the card out of the slot a little.
Step 3: Push the spring button hard in the orientation shown in the figure below, and the CF card on the
right pops up a little. Take it out.
Figure 6-11 Press the spring button to make the card spring out
6-7