Mounting A Switch To The Designated Position; Mounting A Switch Into A Cabinet - 3Com H3C S7503E-S CHASSIS Installation Manual

Mounting a Switch to the Designated Position

Mounting a Switch into a Cabinet

After purchasing an S7500E Ethernet switch, you can mount the switch into an H3C N68 cabinet or a
standard 19" cabinet. The installation methods are similar. The following describes how to mount a
switch into an N68 cabinet.
Figure 3-2 Mount a switch into an N68 cabinet
Installing an N68 cabinet
In a special-purpose N68 cabinet ready for delivery, a place for an S7500E Ethernet switch has been left
and well prepared according to your order, and all accessories except LPUs and cables, have been
installed. For the procedure for installing an N68 cabinet, refer to H3C N68 Cabinet Installation and
Remodel Introduction.
Mounting a Switch
You are recommended to mount an S7500E Ethernet switch in an N68 cabinet in the following way:
1) Before installation, ensure that:
The N68 cabinet has been well fixed. The installation position for the switch has been well arranged
and there is no obstacle around.
The switch is ready for installation and has been carried to a place near the cabinet and convenient
for moving.
An air filter, if required, is already installed because it is inconvenient to mount it onto the switch
that is installed in the cabinet.
2) Mount weight-bearing guide rails on the N68 cabinet based on the installation position of the switch.
(Two types of weight-bearing guide rails are available. One is small guide rails and applicable to
the S7502E and S7503E-S. The other is large guide rails and applicable to the S7500E series
other than the S7502E and S7503E-S.)
3) Mount the cable rack and mounting ears on the switch.
4) Together with another person, carry the switch to the front of the cabinet slowly.
5) Lift the switch a little above the weight-bearing guide rails and put it on the guide rails and adjust its
position.
3-2