You do not need to modify the HyperTerminal's baud rate if you have chosen 9600 bps, and thus you
can skip Step 5 and 6 and go to Step 7 directly. At this time, the system will not display the above
information.
5)
Click Disconnect in the HyperTerminal window to disconnect the HyperTerminal from the switch
before setting a baud rate.
6)
Select File > Properties in the HyperTerminal window, click Configure in the popup dialog box,
and select the baud rate of 19200 bps in the console port configuration dialog box.
Figure 6-1 Properties dialog box
6-8