FUTABA CGY750 Instruction Manual page 36

R G
UDDER
WARNING
mine the proper servo settings. The servo type
parameter within the CGY750 must match the
type of servo you are using. Incorrect setting
may damage the CGY750 or the servo. Incor-
rect setting may also result in a loss of control
during flight.
This parameter controls which direction the
CGH750 (yaw axis) will compensate when the
helicopter rotates. Hold the tail rotor linkage
over the linkage ball on the servo, pick the heli-
copter up by the main shaft and rotate the me-
chanics counter-clockwise. The CGY750 should
compensate by adding clockwise rotation pitch
to the tail rotor blades. If the CGY750 compen-
sates by adding counter-clockwise rotation pitch
to the tail rotor blades, then it will be necessary
to reverse the Compensation Direction setting
by pressing the [+] or [-] data key.
WARNING
Verify that the tail gyro compensates in the
correct direction before flight. If the compensa-
tion direction is incorrect the model will pirou-
ette uncontrollably, at a very high rate.
B
YRO ASIC
S
ETTING
-