FUTABA CGY750 Instruction Manual page 21

WARNING
Newer high end servos and other radio
equipment are capable of placing large de-
mands on the power systems in use today.
When using a regulator you must ensure that
the regulator is capable of delivering the cur-
rent demands of the equipment you have se-
lected. In addition to this make sure the wiring
and switch you have selected are capable of
handling high current draws.
on a flybarless helicopter. Always ensure your
receiver battery is fully charged before each
flight.
Even though the CGY750 is a high perfor-
mance gyro and governor it will be necessary
to ensure that the helicopter mechanics are
also in optimum operating condition. Please
use the guidelines below and address all is-
sues before installing and flying the CGY750.
tempt to fly the CGY750 using a wire driven tail
rotor system.
pulleys, belt, bearings and shafts are in proper
working condition. If any of these items are
damaged or worn they must be replaced.
The linkage rod, tail rotor bell crank, pitch slider
and tail rotor grips must operate without friction
to obtain the best performance from the CGY750.
Binding in the tail rotor control linkage will de-
M
ECHANICS
P
REPARATIONS
-