FUTABA CGY750 Instruction Manual page 76

G
OVERNOR
It sets the throttle servo maximum throw. It is
fundamental for governor operation. It must be
set prior to other function setting. It must be set
when the throttle linkage is changed or trim is
changed as well.
For this setting, idling position is set first, then
high position guided by the display. Push the
data + or – key to memorize. "*Finish*" is dis-
played when the setting is completed. "Error"
is displayed when the setting position is out of
through).
When using the CGY750 for the first time, or
when making changes in the throw of a servo,
always perform the limit setting operation.
It tests the limit point if they are correct. Push
data + or – key. Throttle servo moves to setting
point followed to the display.
B S
ASIC ETTING