FUTABA 9ZAP - PART1 Manual page 63

Programming Servo Delay at Condition Switching
This function is used to set the servo delay for each
channel, from channel 1 to channel 8. Whenever a flight
condition is switched, the system uses the programmed
delay to slow down sudden servo position changes. This
Inputting Channel Delays
The setting screen for this function is called from the
ATV setting screen. If you are not already in the ATV
menu, select it from the condition menu. Next, press the
NXT R key at the ATV setting screen. This action
displays the channel delay setting screen shown below.
Select the desired channel with the F to M keys.
When selected, input the delay with the numeric keys F
to M. The delay may be set independently for each chan-
nel between 0 and 100%. Each 20% delay works out to be
approximately one second, but experiment to be sure
that you get what you want.
Select the next channel with the SEL O key and
repeat these steps to input its delay.
When you are finished, you may return to the ATV
menu by pressing the PRE R key, or you may return
to the Model menu by pressing the N (END) key.
might be used, for example, to prevent a sudden loss of
lift on a sailplane when switching from flaps down for
launch to a regular position for normal flight.
Channel selection keys
After
operation
Before
operation
Common Conditions Section, Page 61
Common Condition Section
Return to
ATV screen
Return to
condition menu