FUTABA 9ZAP - PART1 Manual page 57

Swash Plate Selection Procedure
In the Model Menu, press the SWH key to get the
Swash Plate Selection menu.
Use the (A) key to activate the selection menu, then
use the E to D type selection keys to choose the type
matched to your model. If the selection is O K , press the
YES (E) key, otherwise press the
and choose again.
Rate Setting Procedure
To set the aileron rate. press the B right-arrow key
and use the rate-setting keys E toM. The number keys
( 0 ) through ( 100 ) input the value directly. The
( + ) and ( - ) keys increase or decrease the value by 1.
The +/- may be used to reverse the offset direc-
tion. The default value is 50%, but the setting may vary
between -100 to +100%.
Repeat the rate setting procedure for Elevator by
using the C key, then set the Pitch rate using the D key.
End setting by pressing the END (N) key.
Type Selection Keys
NO (F) key
Model Setting Section, Page 55
Model Setting Section
Return to
Model
Menu