FUTABA 6EXP Instruction Manual page 29

To select the swashplate types:
1. Enter the programming mode and use the MODE key to access the "SWSH" function.
2. To select swashplate type press the DATA INPUT lever upward or downward for about two
seconds. When you are changing swashplate type to 1-S, 3-S or 3-E, the 1-S, 3-S or 3-E on
the display flashes slow to change rapid and then returns slow flashing with conformation
sound.
3. Now it set the swashplate type.
To set the swash AFR:
This function only can set when you selected the 3-S or 3-E swashplate type. There is no swash AFR setting with 1-S type.
This swash AFR function is to use for change the direction and amount of servo movement on aileron, elevator, and pitch.
At first, linkage and set the servo horn length on aileron, elevator, and pitch servos follow by instruction manual comes with
the model. Basically "EPA" (see page17) is set near 100% with these three servos. To set the servo "reveres" function (see
page16) so that swashplate keeps horizontally and moves correct direction up and down by operating pitch control (up and
down throttle stick).
1.Enter the programming mode and use the MODE key to access the "SWSH" function.
2. Swashplate types, Confirm 3-S or 3-E type is selected. If 3-S or 3-E type is not selected,
please see "To select the swashplate types" and set.
3. Use SELECT key to select the channel you wanted to set. Aileron channel "CHA" is
displayed at first and "%" is flashing.
Move the aileron stick left and right to set the direction and amount of movement on the
aileron servo by push up or down DATA INPUT lever. Aileron movement can be adjust from
-100% to +100% .
4. Other channel (elevator and pitch) select by SELECT key to set the direction of movement
and movement amount of servo with same manner of aileron channel setting.
"CHE" is elevator and "CHP" is pitch channel on the Display.
29