Receiver And Servo Connections - FUTABA 6EXP Instruction Manual

Connect the servos to the receiver to perform the functions indicated:
Receiver
output
channel
Aileron -or-right flaperon -or-right elevon (for tail-
1
less models)
Elevator -or-left ruddervator (for V-tail models)
2
-or-left elevon (for tailless models)
3 Throttle
4 Rudder -or-right ruddervator (for V-tail models)
5 Retractable landing gear
6 Flap -or-left flaperon
7 Not used
8 Not used
Receiver on/off switch (the plug colored red
B
goes into the receiver)
The diagram shown is for aircraft models only. Additional servos may have to be purchased separately.
Receiver
Charging
Jack
Harness
(Black)
To Battery
The diagram shown is for helicopter models only. It is necessary to buy an additional gyro separately.
Receiver
Charging
Jack
Harness
(Black)
To Battery

RECEIVER AND SERVO CONNECTIONS

Aircraft (ACRO)
(Red)
Switch
(Red)
Switch
Function
Aileron
Elevator
Throttle
Rudder
Gyro sensitivity
Pitch
Not used
Not used
Receiver on/off switch (the plug colored red
goes into the receiver)
Aileron Servo
(CH1)
Elevator Servo
(CH2)
Throttle Servo
(CH3) (CH6)
Rudder Servo
(CH4)
Flaperon Mode (Dual Aileron
Gear Servo
(CH5)
Flap Servo
(CH6)
Aileron Servo
(CH1)
Elevator Servo
(CH2)
Throttle Servo
(CH3)
Pitch Servo
(CH6)
10
Helicopter (HELI)
(CH1)
(CH2)
(CH4)
Independent Aileron & Flap
Servo, CH1 & 6)
Rudder Servo
Optional
Gyro
System
Gyro sensitivity (CH5)
Rudder (CH4)
(CH1)
(CH6)
(CH2)
(CH4)