Connecting Machine To Power Supply - ELNA 6001 Instruction Book

PDFMAILER.DE
1
5

Connecting Machine To Power Supply

Before connecting the power cord, make sure the
4
voltage and frequency shown on the machine are
identical to your electrical power.
To connect the foot control ... , turn off the power
switch „ . Insert the foot control plug • and machine
plug ‚ into the machine and the power supply plug
2
ƒ into the wall socket.
Your machine may come equipped with a polarized
plug (one prong wider than the other). A polarized
plug reduces the risk of electrical shock. This plug is
intended to fit into a polarized outlet. If the plug does
not fit fully into the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
3
IMPORTANT: When using your sewing machine the
first few times, place waste fabric under the presser
foot and run the machine without thread for a few
minutes. Wipe away excess oil.
For Your Safety
Do not use extension cords or plug adapters.
Do not touch plug with wet hands.
Always turn off the power/light switch first and then
unplug from the electrical outlet. Examples:
Always turn off the power/light switch:
Do not place anything on the foot control.
Do not place heavy items on cords. Do not subject
cords to heat. Do not use damaged cords. Have the
cord repaired immediately.
While the machine is in operation, always keep your
eye on the sewing area and do not touch any mov-
ing parts such as the thread take-up lever, flywheel
or needle.
12
when leaving the machine unattended
when cleaning the machine
when attaching or removing parts such as
needle, presser foot, needle plate
when threading needle or bobbin