D-Link AirPremier N DAP-3525 Quick Install Manual page 5

Option 2:
Deploying Your Access Point without Dynamic IP Addressing
If your network does not automatically assign IP addresses ( No DHCP
service ), follow these steps to properly configure your Access Point:
Configure APs
Step 1: Connect the Access Point directly to your computer using an
Ethernet cable.
DAP-3525
Step 2: Configure the Ethernet connection of your computer as follows:
Windows 7 - Click on Start > Control Panel > Network and Internet >
®
Network and Sharing Center > Change Adapter Setting.
Windows Vista
Network and Sharing Center > Manage Network Connections.
Windows XP - Click on Start > Control Panel > Network Connections.
®
Windows 2000 - Right-click My Network Places > Properties.
®
R i g h t- c l i c k o n t h e Lo c a l A re a
Connection which represents your
network adapter and select Properties.
Highlight Internet Protocol (TCP/IP)
and click Properties.
Click Use the following IP address
and enter an IP address that is on
the same subnet as your network
or the LAN IP address on your new
DAP-3525.
Click OK twice to save your settings.
TM
- Click on Start > Control Panel > Network and Internet >
®
PC or Mac
5