Installation / Mounting; Connect The Ethernet Cable - D-Link AirPremier N DAP-3525 Quick Install Manual

Dual band exterior poe access point
Table of Contents

Advertisement

Installation / Mounting

This product should ONLY be installed by an experienced installer who is
familliar with local building and safety codes and where ever applicable, is
licensed by the appropriate authorities. Failure to do so may void the D-Link
product warranty and may expose the end user or the service provider to legal
and financial liabilities. D-Link and its resellers or distributors are not liable for
injury, damage, or violation of regulations associated with the installation of
outdoor units or antennas.
A safety grounding system is necessary to protect your outdoor installation
from lightning strikes and the build-up of static electricity. The grounding
system must comply with the National Electrical Code and safety standards
that apply in your country. Always check with a qualified electrician if you
are in doubt as to whether your outdoor installation is properly grounded.
Note: DAP-3525 is certified to IP65 which means the device is protected
from dust and low pressure jets of water from all directions - limited ingress
permitted. It is recommended to place this device under a roof.

Connect the Ethernet Cable

Step 1: Connect the supplied Ethernet cable with the waterproof enclosure to the
Ethernet port on the DAP-3525.
9
TM

Advertisement

Table of Contents
loading

Table of Contents