Invertek Drives OPTIDRIVE E3 Service Manual
Ode-3 frame size 3 ip20, frame size 4 240v - 480v
Hide thumbs
Also See for OPTIDRIVE E3:
- User manual (52 pages) ,
- Service manual (23 pages) ,
- User manual (40 pages)
Related Manuals for Invertek Drives OPTIDRIVE E3
Summary of Contents for Invertek Drives OPTIDRIVE E3
- Page 1 2016 SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 SERVICE MANUAL Frame Size 4 240V - 480V Assembly/disassembly IP20 Page 1 of 9...
-
Page 2: Table Of Contents
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 Contents Page no: Drive cover removal procedure ..................... 3 Ribbon cable disconnection ....................5 Fan disconnection ......................... 6 EMC disconnection ....................... 6 IGBT removal ........................7 DC capacitor removal ......................8 Page 2 of 9... -
Page 3: Drive Cover Removal Procedure
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 Drive cover removal procedure Place the drive on a flat surface Push the tab highlighted opposite in red inwards. At the same time pull the plastic cover upwards in the direction highlighted in orange Repeat the process for the opposite side of the drive... - Page 4 SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 With both clips unclipped, the drive should look as shown opposite Push the tab highlighted opposite in red inwards. At the same time pull the plastic cover upwards in the direction highlighted in orange Repeat the process for the opposite side of the drive...
-
Page 5: Ribbon Cable Disconnection
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 With all 4 x tabs unclipped from the base, the drive should look as shown opposite Push the remaining tab highlighted opposite in red inwards. At the same time pull the plastic cover upwards in the direction highlighted in orange Please note that a ribbon cable connects the top cover to the base unit! Ribbon cable disconnection... -
Page 6: Fan Disconnection
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 Fan disconnection The fan connection is highlighted opposite. This can be disconnected using a terminal screwdriver EMC disconnection Using a torx T20 screwdriver remove the screw (1Nm) Page 6 of 9... -
Page 7: Igbt Removal
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 Using a torx T20 screwdriver remove the screw (1Nm) IGBT removal Using a torx T20 screwdriver remove the 4 x screws (4Nm) Page 7 of 9... -
Page 8: Dc Capacitor Removal
SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 DC capacitor removal Using a torx T20 screwdriver remove the 4 x screws (4Nm) With the power board removed access can now be made to the DC capacitors Capacitors held in position by 4 x screws (1.5Nm) Page 8 of 9... - Page 9 SERVICE MANUAL ODE-3 FRAME SIZE 3 IP20 2016 The power board is now removed and can be reworked as required Page 9 of 9...
Need help?
Do you have a question about the OPTIDRIVE E3 and is the answer not in the manual?
Questions and answers