(MCU) that has a 3.3V I C or SPI interface. The IC mounted on both TBMV300 boards is the MV300. Since the MV300 and MVQ300 are functionally equivalent, the TBMV300 can also be used for evaluation of MVQ300. Board Types The test board is available in two versions for different communication interfaces.
USER GUIDE – MV300/MVQ300 TEST BOARD (TBMV300) Items Compatible with the Test Board The table below lists all items that are compatible with the MV300/MVQ300 test board (items below must be ordered separately): Part Number Item Includes one USB cable, one ribbon cable (not included with the TBMV300-Q-LT;...
R8 footprint and add a ferrite bead that filters the high-frequency noise on the power supply. If necessary, move the C1 and C2 capacitors further away from the MV300. C1 and C2 can be soldered to the C3 and C4 footprint.
R8 footprint and add a ferrite bead that filters the high-frequency noise on the power supply. If necessary, move the C1 and C2 capacitors further away from the MV300. C1 and C2 can be soldered to the C3 and C4 footprint.
3, 4 Figure 3 title. Notice: The information in this document is subject to change without notice. Please contact MPS for current specifications. Users should warrant and guarantee that third-party Intellectual Property rights are not infringed upon when integrating MPS products into any application.
Need help?
Do you have a question about the MV300 and is the answer not in the manual?
Questions and answers