External Switch Control; Function Assignment - Pioneer DVD-V7400 Command Protocol Manual

9.

EXTERNAL SWITCH CONTROL

To activate a function, create a switch contact with an electrical ground (Pin 1). Check
Chapter 2 to verify pin (Pin 6 through Pin 13) and terminal (SW1 ~ SW8) assignments.
There are three SW functions in the EXTERNAL SWITCH CONTROL.
1. To recall Barcode/Command Stacks and execute
The function, STACK GROUP 1 to STACK GROUP 27, is similar to a combination
of remote control buttons to recall and execute a stack.
2. To execute the function as a remote control command
The function acts the same as the buttons (ENTER, PLAY, STOP, etc.) on a remote
control excluding SCAN FWD/REV.
A scan request sent through the remote control may be Paused. However, once a
scan command is halted, the request is lost.
3. To execute as an advanced remote control button
Advanced remote control commands such as OPEN/CLOSE, numbers from 10 to
20, and the four slanting arrows may be sent as a switch control command.
Note for additional assistance, please refer to Product Information Bulletin (PIB) 152601
DVD-V7400 and Jama Port Control available on the Pioneer Electronics website under
Service & Support – Business Solutions Products.
9.1

Function Assignment

Create a Circuit Controller or a Diode Matrix Circuit (refer to the table below).
Diode Assignment List
SW1 SW2
↑ ↓
X
X
X
X
X
X
SW3 SW4 SW5
← → ENTER
X
X
X
X
X
X
X
- 87
SW6 SW7 SW8
X Y Z
X
X
X
Internal Registers
Function
↑*
↓*
←*
→*
ENTER*
STACK GROUP1*
STACK GROUP2*
STACK GROUP3*