RP7 Adjustable Stand
NOTE:
This section provides instructions for installing the RP7 Adjustable Stand if the stand was
purchased separately.
1.
Prepare the computer for disassembly
2.
Remove the power supply cover
3.
Remove the decorative panel
4.
Remove the rear I/O panel
5.
Attach the RP7 display head to the stand's mounting bracket by aligning the slots on the display
head with the hooks on the mounting bracket and sliding the display down (1). Install the three
screws included with the stand through the mounting bracket and into the display head to secure
it in place (2).
(Preparation for Disassembly on page
(Power Supply Cover on page
(Decorative Panel (IMD) on page
(Rear I/O Panel on page
47).
48).
49).
RP7 Adjustable Stand
46).
55