HP RP7 Model 7800 Maintenance And Service Manual page 29

Table 3-6 Computer Setup—Advanced (for advanced users) (continued)
●
Bus Options On some models, allows you to enable or disable:
●
●
Device Options Allows you to set:
●
●
●
●
●
●
●
●
●
●
NOTE:
Resources you can change include:
◦
Parallel Port
◦
Serial Port A
◦
Serial Port B
◦
Serial Port A Voltage
◦
Serial Port B Voltage
Available settings for powered ports are:
◦
0V (default)
◦
+5V
◦
+12V
PCI SERR# Generation. Default is enabled.
PCI VGA Palette Snooping, which sets the VGA palette snooping bit in PCI configuration
space; only needed when more than one graphics controller is installed. Default is disabled.
Turbo Mode (enable/disable). Allows you to enable and disable the Intel Turbo Mode feature,
which allows one core of the system to run at a higher than standard frequency and power if
other cores are idle. Default is enabled.
Printer mode (Bi-Directional, EPP + ECP, Output Only). Default is EPP+ECP.
Num Lock State at Power-On (off/on). Default is off.
Integrated Video (enable/disable). Use this option to disable the integrated video controller
when another video controller is present in the system. Default is enabled.
Internal Speaker (some models) (does not affect external speakers). Default is enabled.
NIC Option ROM Download (PXE, iSCSI, disabled). The BIOS contains an embedded NIC
option ROM to allow the unit to boot through the network to a PXE server. This is typically
used to download a corporate image to a hard drive. The NIC option ROM takes up memory
space below 1MB commonly referred to as DOS Compatibility Hole (DCH) space. This
space is limited. This F10 option will allow users to disable the downloading of this
embedded NIC option ROM thus giving more DCH space for additional PCI cards which may
need option ROM space. The default will be to have the NIC option-ROM-enabled. Default is
PXE.
Multi-Processor (enable/disable). Use this option to disable multi-processor support under
the OS. Default is enabled.
System Health Timer Timeout (Disabled, 1 min, 5 min, 15 min). Allows you to set a timer to
reset the system in case of a lock up. An expired timer indicates the system hung. Default is
disabled.
Cash Drawer Port. Use this option to enable/disable the cash drawer port that comes on the
system board.
Hard Drive Activity LED. Use this option to enable/disable the hard drive LED. When this
feature is disabled, there is no visual indication for hard drive activity.
To hide a device, see Security > Device Security.
Computer Setup (F10) Utilities 19