Duco DucoVent Design AK Square Standard Installation Manual

Installation manual
DucoVent Design AK
L2005192-A 04.03.2025
Application
Design vent with acoustic damping, to
be mounted in a plasterboard ceiling
(or wall), to be connected to a duct of
^ 125 mm.
Mounting and pre-adjustment
1
^132 mm
Cut out a hole in the
plasterboard at the desired
location. Make sure the
surface is flat and even.
Calibrating flow rates
SITUATION 1 :
One vent per zone
Set all vents to the fully open
position, regardless of the
desired flow rate.
EXAMPLE:
Zone Zone
1 2
Item number
Suitable for
2
Pre-adjustment: remove
the acoustic rings from the
foam pack according to the
desired flow rate. See the
overview under "Calibrating
flow rates". Leave at least
the outer ring in place for an
acoustic effect!
SITUATION 2 :
Multiple vents per zone
with equal flow rates
Set all vents to the fully open
position, regardless of the desired
flow rate. With DucoVent Design
vents, turn the cone on the cover
plate to the fully open position.
EXAMPLE:
Zone 1
Square Square
Standard XL
0000-7006 0000-7007 0000-7008
Extraction / Extraction /
Extraction
Supply
3
When mounting less than
20 cm from a wall or corner:
mount the directional plates.
Multiple vents per zone
with different flow rates
Set the vents so they match the desired flow
rate in accordance with the table.
EXAMPLE:
Zone 1
+
Rounded
Round Square
Standard
0000-7012 0000-7013
Extraction /
Extraction
Supply
4
Place the vent in the opening.
SITUATION 3 :
Acoustic
rings
Rounded
Square
XL
Supply
Position
100 %
open
50 %
open
25 %
open
1