Duco DucoBox Energy Premium Manual
Hide thumbs
Also See for DucoBox Energy Premium:
- Installation manual (32 pages) ,
- Manual (16 pages) ,
- Maintenance instruction (24 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Duco DucoBox Energy Premium
Summary of Contents for Duco DucoBox Energy Premium
- Page 1 BE(en) DucoBox Energy Premium HANDS ON...
- Page 2 1. Connector & buttons Extract fan Blue Yellow Red White DUCO Switch Wired Contact DUCO Network Tool Power 230 VAC Temperature sensors Antenna 2-Zone Pressure sensors HIGH INST Bypass Heater Supply Fan Optional Boxsensor (only one boxsensor can be connected)
-
Page 3: Led Indication
2. LED indication RED (blinking slowly) RED (blinking rapidly) Not in network Logging in GREEN (blinking slowly) GREEN (blinking rapidly) In network In network, waiting for associated components YELLOW (on) YELLOW (blinking slowly) Initialising Transitional phase (please wait) (system configuration in progress) WHITE or OFF Normal BLUE... -
Page 4: Connecting Air Ducts
3. Connecting air ducts When connecting the ductwork, it must be taken into account whether it is a left-hand or right-hand configuration. Air duct connections are also indicated on the DucoBox Energy Premium by means of stickers. LEFT-HAND configuration RIGHT-HAND configuration... -
Page 5: Next Steps
4. Commissioning Switch on the power to the DucoBox Energy Premium (plug into power socket). When the DucoBox Energy Premium starts up for the first time, you will be asked to enter a few basic settings. Navigate using the arrow keys ( ) and confirm using enter ( ). - Page 6 You need to take account of zone designations if you are utilising an integrated 2-zone system. Zone 1 is the bevelled side of the DucoBox Energy Premium in each case. Pairing control components with the DucoBox Energy Premium 1. Activate advanced mode: •...
- Page 7 3. Start the WIZARD. The DucoBox Energy Premium will automatically detect whether it is a 1-zone or a 2-zone system. The system now enables control components to be paired with the entire system (step 4), zone 1 (step 5) or zone 2 (step 6).
- Page 8 For 2-zone system only Pair the desired control components with zone 1. This could be the daytime zone (living room, office, etc.) Then confirm by pressing enter ( ). For 2-zone system only Pair the desired control components with zone 2. This could be the night zone (bedrooms) etc.) Then confirm by pressing enter ( ).
- Page 9 Tips: The network can be wiped or a full reset of the DucoBox Energy Premium can be carried out in the event of any problems. To do this, refer to the following functions under the INSTALLATION menu (visible only after activating advanced mode).
- Page 10 6. Pre-setting vents In order to calibrate the air supply and exhaust correctly, these vents must be set depending on the situation in accordance with the table below. In order to configure the air supply and exhaust correctly, these vents must be set so they match the desired flow rate in line with the table opposite.
- Page 11 7. Calibrating flow rates Close all windows and doors. Ensure that all duct openings in the DucoBox Energy Premium are fully closed and that the DucoBox Energy Premium cover is closed. Avoid air leaks in the ventilation ducts. Open all interior doors between the various zones.
- Page 12 The calibrated flow rates can be checked at the various vents once adjustment and calibration have been completed. Do this by going into advanced mode and select “CALIBRATION → VERIFY HIGH LEVEL”. The DucoBox Energy Premium will now ventilate for 30 minutes at its calibrated ventilation setting.
- Page 13 9. Electronical Installation Removing / replacing components Removing paired components from the network or replacing is only possible within 30 minutes after the component is paired in or is restarted. Restarting can be done by disconnecting the power for a moment. After a time-span of 30 minutes, remove and replace operations are ignored.
- Page 14 5. Switch the DUCO WiFi Router on (slider button on the side at ‘R’ for ‘Router’) 6. Switch on the DucoBox. 7. Connect your smartphone to the DUCO Wi-Fi Router via Wi-Fi. You will find the Wi-Fi name (SSID) and password on the back of the Wi-Fi Router.
- Page 15 WIFI PASSWORD...
- Page 16 We inspire at www.duco.eu L2001033-B 26.08.2021...
Need help?
Do you have a question about the DucoBox Energy Premium and is the answer not in the manual?
Questions and answers