Related Manuals for Grandstream Networks GWN7811P
Summary of Contents for Grandstream Networks GWN7811P
- Page 1 Grandstream Networks, Inc. GWN7811P Enterprise Layer 3 Managed Network Switch Quick Installation Guide For Certification, Warranty and RMA information, please visit www.grandstream.com ~ 1 ~ ~ 2 ~...
- Page 2 Do not expose this device to environments outside of the following humidity range: 10-90% RH (non-condensing) for operation and 5-95% RH (non-condensing) for storage. Do not power cycle your GWN7811P during system boot up or firmware upgrade. You may corrupt firmware images and cause the unit to malfunction.
- Page 3 Port 1-8 8x Ethernet RJ45(10/100/1000Mbps), Solid blue Normal use used for connecting terminals Flash blue Privisioning Note: GWN7811P Ethernet ports support Solid red Upgrade failed PoE/PoE+ Flashing red Factory reset Ethernet ports’ LED indicators For all ports, port off Port SFP+ 1/2 2x 10Gbps SFP+ ports &...
- Page 4 3. Connect the other end of the ground cable to other device that 1. Place the smooth side of the fixing strap towards the power has been grounded or directly to the terminal of the ground bar in outlet and insert it into the hole on the side of it. the equipment room.
- Page 5 3. Wrap the strap of the protective cord around the power cord and 1. Grasp the fiber module from the side and insert it smoothly along lock it tightly. Fasten the straps until the power cord is securely the switch SFP+ port slot until the module is in close contact with fastened.
- Page 6 3. Flip the switch over and place it smoothly on the table. Rubber footpads Back of switch Circular groove Install on the Wall Note: For GWN7811P, please use extended L-shaped rack-mounting kits in the package. ~ 9 ~ ~ 10 ~...
- Page 7 Note: For GWN7811P, please use extended L-shaped rack-mounting kits in the ACCESS & CONFIGURE package. Note: If no DHCP server is available, the GWN7811P default IP address is 1. Check the grounding and stability of the rack. 192.168.0.254. ~ 11 ~...
- Page 8 “admin” and the default random switch. password can be found at the sticker on the GWN7811P switch). 2. Set the Ethernet (or local connection) IP address of the PC to 192.168.0.x (“x” is any value between 1-253), and the subnet mask to 255.255.255.0, so that it is in the same network segment with...
- Page 9 é é é é ~ 15 ~ ~ 16 ~...
Need help?
Do you have a question about the GWN7811P and is the answer not in the manual?
Questions and answers