How To Add Fluid - Geo TRACKER 1993 Manual

Service & Appearance Care
. . .
236
Let the engine run at idle for three
minutes or more.
To check the fluid hot or cold:
Park your vehicle on a level place.
Place the shift lever in P (Park) with
the parking brake applied.
With your foot on the brake pedal,
move the shift lever through each gear
range, pausing for about three seconds
in each range. Then, position the shift
lever in P (Park).
Then, without shutting off the engine,
follow these steps:
1.
Pull out the dipstick and wipe
it
with
2. Push it back in all the way, wait
a clean rag or paper towel.
three seconds and then pull it back
out again.
3. Check both sides
of the dipstick, and
read the lower level. The fluid level
must be in the COLD (A) area for a
cold check or in the HOT (B) or
cross-hatched area for a hot check.
4. If the fluid level is where
it
should
be, push the dipstick back in all the
way.
How to Add Fluid:
Refer to the Maintenance Schedule to
determine what kind of transmission
fluid to use. See "Recommended Fluids
and Lubricants" in the Index.
If the fluid level is low, add only
enough of the proper fluid to bring the
level up into the COLD area for a cold
check or the HOT area for a hot check.
It doesn't take much fluid, generally less
than a pint. Don't overfill. We
recommend you use only fluid labeled
DEXRON@-11, because fluids with that
label are made especially for our
automatic transmission. Damage caused
by fluid other than DEXRON@-I1 is not
covered by your new vehicle warranty.