Page 1
FOR USE ONLY WITH THE 56V LITHIUM-ION POWER HEAD PH1400E\PH1420E OPERATOR'S MANUAL EDGER ATTACHMENT MODEL NUMBER EA0800/EA0820 WARNING: To reduce the risk of injury, the user must read and understand the Operator’s Manual before using this product. Save these instructions for future reference. MNL_EGO_EA0800/EA0820_AV03.01_240820...
Page 2
1. End Cap 9. Depth 11. Cotter Adjusting 2. Edger Shaft Guide Bar 10. Debris Flap 13. Guide Plate 12. Screw to lock guide plate in place 3. Blade Guard 7. Hex Wrench 6. Guide Wheel 8. Multi-functional Wrench 5. Depth Adjusting Knob 4.
Page 3
No more than 5mm Cotter Pin Inner Flange Gear Case Slot in the Inner Flange Bulge on the Inner Flange Cotter Inner Flange Outer Flange Motor Shaft Blade...
Page 5
READ ALL INSTRUCTIONS! Indicates a potential Safety Alert personal injury hazard. READ OPERATOR’S MANUAL To reduce the risk of injury, user must read and Read Operator’s understand operator’s WARNING: To ensure safety and reliability, all Manual manual before using this repairs and replacements should be performed by a product.
Page 6
◾ Use only with EGO’s battery packs and chargers listed 4) If edger starts to vibrate abnormally (check below: immediately). ◾...
Page 7
1. End Cap ◾ 2. Edger Shaft If situations occur that are not covered in this manual, 3. Blade Guard use care and good judgment. Contact the EGO Service 4. Blade Centre for assistance. 5. Depth Adjusting Knob ◾ Save these instructions. Refer to them frequently and 6.
Page 8
Hold the edger with your right hand on the rear handle and your left hand on the front-assist handle. Keep a firm This edger attachment is designed for use with EGO 56V grip with both hands while operating the tool. The edger Lithium-ion Power Head PH1400E\PH1420E.
Page 9
Recommend 4. Remove the spring washer, plain washer 1, guide replace only with EGO edger blade, see “Recommended wheel, bushing and plain washer 2 from the screw Blade” section. pole (Fig. K). Check and replace them if they are worn.
Page 10
5. Mount the screw pole through the depth-adjusting TRANSMISSION GEARS LUBRICATION guide bar first, and then mount the plain washer 2, The transmission gears in the gear case need be bushing and new wheel, then mount the plain washer lubricated periodically with gear grease. Check the gear 1, spring washer and depth-adjusting knob onto the case grease level about every 50 hours of operation by screw pole in the sequence shown in Fig.
Page 11
Motor fails to start. ◾ ◾ The battery pack is depleted. Charge the battery pack with EGO chargers listed in this manual. ◾ ◾ The lock-off button and trigger are not Press down the lock-off button and depressed simultaneously.
Page 12
EGO accessories is 90 days for residential purpose, 30 days for industrial, professional or commercial purpose. These parts are covered for 90/30 days from manufacture defects in normal working conditions.
Page 13
PROFESSIONAL USE (ANY PRODUCT OR MODEL # CONSUMER USE COMMERCIAL, AGRICULTURAL, (PERSONAL, HOUSEHOLD USE) INSTITUTIONAL, OR INCOME-PRODUCING USE) EGO Power+ Outdoor Power Equipment and 5 years 1 year Portable Power Products EGO Power+ Battery Packs and Chargers 3 years 1 year...
Need help?
Do you have a question about the Power+ EA0800 and is the answer not in the manual?
Questions and answers