Chicco Fit360 LeverLock Manual

Setting Up

Please also refer to the instructions that came with your product.
NOTE: Door Cover intended for use in Rear-Facing mode.

1. Open the LeverLock Door by pushing in at the top of the lever, and pulling the lever out.
   
2. Slide the Door Cover down onto theLeverLock Door, as shown.
   
3. Push both hook and loop straps through the slot at the bottom of the LeverLock Door.
   
4. Turn the Base around and finish pulling both hook and loop straps up through the slot at the bottom of the LeverLock Door.
   
5. Pull the hook and loop straps together making sure they are attached tightly. Check tomake sure the orange LeverLock components on the top and sides of the LeverLock Door are not covered by the Door Cover.
   
6. To open the LeverLock Door while using the Door Cover slide your hand underneath the fabric slot at the front of the Door Cover and open the LeverLock Door by pushing in at the top of the lever, and pulling the lever out.
   

DO NOT use Door Cover in Forward- Facing mode. If you have a problem, retry these instructions provided AND review your User Guide. If you still have problems, STOP, Do Not use the Car Seat, and call Chicco at 1-877-424-4226.