Testing Your Disaster Recovery Set - HP C4405A - Colorado 14GB Tape Drive User Manual

To create your Disaster Recovery Set:
1. Select Recovery Wizard from the Tools menu.
The Recovery Wizard appears.
2. Follow the instructions on the Wizard screens to create your Disaster
Recovery Set.
It is recommended that you label your media when prompted in the
Wizards, and store your DR Set in a safe place. A new Disaster Recovery Set
should be created when new hardware or software has been added to your
system, or if many changes have been made to your files since the last DR
Set was created.
Note:

Testing your Disaster Recovery Set

Note:
After you have created the Disaster Recovery Set, you will be asked if you
would like to test the DR Set. Testing the DR Set is very similar to performing an
actual recovery; however, be sure to stop before recovering your data. This test
is to verify that your drive is responding properly.
To test your Disaster Recovery Set:
1. Insert the Windows Startup Disk (diskette #1 of the DR Set) into your
machine's 3.5" boot floppy drive and restart your computer.
A DOS screen appears.
2. If a Windows Startup Diskette #2 was created (not all systems require the
creation of a second diskette), insert that diskette into your machine's 3.5"
boot floppy drive, then press any key.
The Disaster Recovery screen appears.
3. Press F5.
For Windows 9x only — If you are using a SCSI device for
Disaster Recovery, you may be prompted for a DOS ASPI driver.
Please refer to the README.TXT for instructions on entering the
correct drivers when creating the DR Set.
This section applies to Windows 9x only.
Creating the Disaster Recovery Set 47