Using The Conversion Kit - HP C1593B - SureStore DAT Tape 5000e Drive Installation Manual

HP SureStore DAT
Installation Guide

Using the Conversion Kit

1
Figure 1.4 Removing the drive rails prior to installation in a 3½-inch bay
2
Figure 1.5 Removing the 5¼-inch panel
1-12
Unscrew the four screws and remove the rails from the tape drive.
Use a screwdriver to release the 5¼-inch front panel from the tape drive
and remove it. Fit the 3½-inch front panel and push firmly until the
panel clicks into place.
Note: Some drives have
clips on the sides of the
unit.