Firmware Upgrade Parameters - Cisco SPA921 - - IP Phone Provisioning Manual

Provisioning Field Reference

Firmware Upgrade Parameters

Firmware Upgrade Parameters
Cisco Small Business IP Telephony Devices Provisioning Guide
The following table defines the function and usage of each parameter in the
Firmware Upgrade section of the Provisioning tab.
Parameter Name
Upgrade_Enable
Upgrade_Error_Retry_Delay
Downgrade_Rev_Limit
Upgrade_Rule
Log_Upgrade_Request_Msg
Description and Default Value
Enables firmware upgrade operations
independently of resync actions.
The default value is Yes.
The upgrade retry interval (in seconds) applied
in case of upgrade failure. The device has a
firmware upgrade error timer that activates
after a failed firmware upgrade attempt. The
timer is initialized with the value in this
parameter. The next firmware upgrade attempt
occurs when this timer counts down to zero.
The default value is 3600 seconds.
Enforces a lower limit on the acceptable
version number during a firmware upgrade or
downgrade. The device does not complete a
firmware upgrade operation unless the
firmware version is greater than or equal to this
parameter.
The default value is (empty).
This parameter is a firmware upgrade script
with the same syntax as Profile_Rule. Defines
upgrade conditions and associated firmware
URLs.
The default value is (empty).
The syslog message that is issued at the start
of a firmware upgrade attempt.
The default value is $PN $MAC -- Requesting
upgrade $SCHEME://$SERVIP:$PORT$PATH.
4
89