Enables; Triggers - Cisco SPA921 - - IP Phone Provisioning Manual

Voice system, voice gateways, and ip telephones
Hide thumbs Also See for SPA921 - Cisco - IP Phone:
Table of Contents

Advertisement

Creating Provisioning Scripts
Using Provisioning Parameters
Cisco Small Business IP Telephony Devices Provisioning Guide

Enables

All profile resync and firmware upgrade operations are controlled by the
Provision_Enable and Upgrade_Enable parameters. These parameters control
resyncs and upgrades independently of each other. These parameters also
control resync and upgrade URL commands issued through the administration
web server. Both of these parameters are set to yes by default.
In addition, the Resync_From_SIP parameter controls requests for resync
operations via a SIP NOTIFY event sent from the service provider proxy server to
the IP Telephony Device. If enabled, the proxy can request a resync by sending a
SIP NOTIFY message containing the Event: resync header to the device.
The device challenges the request with a 401 response (authorization refused for
used credentials), and expects an authenticated subsequent request before
honoring the resync request from the proxy. The Event: reboot_now and Event:
restart_now headers perform cold and warm restarts, respectively, are also
challenged.
The two remaining enables are Resync_On_Reset and
Resync_After_Upgrade_Attempt. These determine if the device performs a
resync operation after power-up software reboots and after each upgrade
attempt.
When enabling Resync_On_Reset, the device introduces a random delay
following the boot-up sequence before actually performing the reset. The delay is
a random time up to the value specified in Resync_Random_Delay (in seconds). In
a pool of IP Telephony Devices, all of which are simultaneously powered up, this
introduces a spread in the times at which each unit initiates a resync request to the
provisioning server. This feature can be useful in a large residential deployment, in
the case of a regional power failures.

Triggers

The IP Telephony Device is designed to resync with the provisioning server
periodically. The resync interval is configured in Resync_Periodic (seconds). If this
value is left empty, the device does not resync periodically.
The resync typically takes place when the voice lines are idle. In case a voice line
is active when a resync is due, the IP Telephony Device delays the resync
procedure until the line becomes idle again. However, it waits no longer than
Forced_Resync_Delay (seconds). A resync may cause configuration parameter
values to change. This, in turn, causes a firmware reboot, which terminates any
voice connection active at the time of the resync.
2
51

Advertisement

Table of Contents
loading

Table of Contents