Provisioning States - Cisco SPA921 - - IP Phone Provisioning Manual

Provisioning Cisco Small Business VoIP Devices

Provisioning States

Provisioning States
Cisco Small Business IP Telephony Devices Provisioning Guide
The provisioning process involves four provisioning states, as described in the
following table.
Flow Step
MFG-RESET
SP-CUST
Step Description
Manufacturing Reset: The device returns to a fully unprovisioned
state. All configurable parameters regain their manufacturing
default values.
Manufacturing reset can be performed through the following IVR
sequence: ****RESET#1#
Allowing the end user to perform manufacturing reset
guarantees that the device can always be returned to an
accessible state.
Service Provider Customization: The Profile_Rule parameter is
configured to point to a device-specific configuration profile,
using a provisioning server that is specific to the service
provider.
There are three methods:
•
Auto-configuration via local DHCP server. A TFTP server
name or IPv4 address is specified by DHCP on the local
network. The indicated TFTP server carries the desired
Profile_Rule entry in the CFG file /spa962.cfg
•
Enter a resync URL. A URL starts a web browser and
requests a resync to a specific TFTP server by entering the
following URL syntax: http://x.x.x.x/admin/resync?prvserv/
device.cfg
where x.x.x.x is the IP address of the IP Telephony
Device and prvserv is the target TFTP server, and device.cfg
is the name of the configuration file on the server.
•
Edit Profile_Rule parameter. Open the provisioning pane on
the web interface, and enter the TFTP URL in the
Profile_Rule parameter: for example, prserv/spa962.cfg.
•
The spa962.cfg file modifies the Profile_Rule to contact a
specific TFTP server and to request a MAC-address
specific CFG file. For example, the following entry contacts a
specific provisioning server, requesting a new profile unique
to this unit:
Profile_Rule tftp.callme.com/profile/$MA/
spa962.cfg;
1
18