Table of Contents
Advertisement
Chapter 2. Installation
The VXA-2 Internal Tape Drive is compatible with several xSeries servers. For a list
of supported servers go to http://www.pc.ibm.com/us/compat and click on "Tape
Backup Units." Refer to the documentation that comes with the server for
instructions on installing the tape drive. If you cannot locate your xSeries server
user manual, follow the instructions in the following sections to install the tape
drive.
Installation requirements
To install the tape drive in your xSeries server, you will need the following:
v A low voltage differential (Ultra2) SCSI host adapter
v Documentation for your computer, SCSI bus adapter, or external enclosure
v Phillips head and flat blade screwdrivers for the mounting screws, and for
v Flat-nose pliers (optional) to install and remove jumpers
v An available 5.25-inch half high drive bay
Preparing for installation
To prepare for installation, complete the following procedure:
1. Touch a known grounded surface to discharge static electricity from your body
2. Turn off all devices attached to the computer in which you plan to install the
3. Disconnect all power cables.
4. Remove the drive bay's cover plate according to the system manufacturer's
5. Before opening the static-protective bag containing the tape drive, touch the
Attention: Tape drives are sensitive to static electricity discharge. The drive is
wrapped in a static-protective bag to prevent damage.
The tape drive complies with industry-standard, 5.25-inch half-high form factor
mounting requirements and can be mounted either horizontally or vertically, but
not upside down. When installing the tape drive, refer to Figure 2-1 on page 2-2 for
the location of the back-panel components.
© Copyright IBM Corp. 2003
opening your computer
and ensure that the work area is free from conditions that could cause ESD.
drive, then turn off the computer.
instructions.
bag to an unpainted metal surface on the computer for at least two seconds.
Remove the drive from the static-protective bag. If you must put the drive
down, place the drive on the static-protective bag. Do not touch any exposed
components of the tape drive. Instead, handle it carefully by the edges.
2-1
Advertisement
Table of Contents
