Table of Contents
Advertisement
240
Fuses and light bulbs
– Remove the rubber protective cap
A
– Unplug plug
.
1
– Take the faulty bulb out of the fixture
a new one in the reverse procedure.
– Insert the protective cap.
Rear light unit
Fig. 194 Removing the rear light unit / disconnecting the plug connection
– Open the boot lid.
– Unscrew the light with the aid of the Torx wrench from the vehicle tool kit. The
shorter side of the wrench is used for loosening the screws and the longer side for
screwing the screws out completely
– Grasp the light at the top and bottom part and pull it slightly to the rear.
– Disconnect the plug connection by pressing the catches in direction of arrow
and by pulling them in direction of arrow
A
page 238, fig.
188.
A
A
by turning in direction of arrow and insert
2
A
fig.
194.
1
A
fig.
194.
3
Changing light bulbs in the rear light unit
Fig. 195 Remove the middle part of the light / rear light unit: Fitting position of the bulbs
– Unscrew the securing screw
catches in direction of arrow
– Remove the plastic lamp holder.
– Replace the defective light bulb.
– In order to replace a bulb for the brake light, reversing light, rear fog or turn signal
light, turn the fixture of the bulb to the left up to the stop and take the bulb out of
the housing or pull the bulb for the parking light out of the fixture
– Change the bulb, install again the fixture with the bulb in the housing and turn it to
the right up to the stop or insert it.
– Insert the plastic lamp holder into the illumination unit until the interlocks are
heard to engage and screw in the securing screw with the aid of the Torx wrench
fig.
195.
A
2
– Reconnect the plug connector and insert the bulb in the original position.
fig. 194
– Screw on the bulb
Fitting position of the light bulbs in the rear light unit
A
- Brake lights
1
A
- Reversing light
2
A
- Rear fog light
3
A
- Turn signal lights
4
A
with the aid of the Torx wrench and press the three
A
fig.
195.
- left.
fig. 195
fig.
195.
Advertisement
Table of Contents
