Demco Kalos Leg & Caster Assembly Instructions

Kalos Desks with Quickmounts (
Required for leg assembly:
#2 Phillips screwdriver
9/ 1 6" wrench
Rubber mallet
STEP 1:
Carefully remove outer packaging. Place tabletop face-down on a
clean, non-scratching surface.
STEP 2:
Set leg height using the Table Height charts (below) as a guide. Use
provided Allen wrench to tighten set screws. Check that all legs are
set to the same height.
Desk/Table with Glides
Table Height Leg Hole Number
22" H 1
23" H 2
24" H 3
25" H 4
26" H 5
27" H 6
28" H 7
29" H 8
30" H 9
31" H 10
32" H 11
33" H 12
34" H 13
STEP 3:
Heavy-duty steel brackets on the underside of the tabletop have been pre-installed for perfect leg positioning and quick, easy assembly.
For each leg: Turn leg upside down and slide fully into pre-installed bracket. Gently tap leg into position with rubber mallet if needed.
Insert Phillips screw through slotted center hole and screw into tabletop. Tighten fully.
Once legs are secure, get help turning table upright. Adjust nylon glides or casters to level table.
Pre-installed leg
mounting bracket
Pre-drilled
pilot hole
Questions? Contact Demco Customer Service at custserv@demco.com or 800.962.4463 (Monday–Friday, 8 a.m.–4:30 p.m. CT).
For Small Rectangles, Share, Arrow, and Dart, see page 2.)
Included for leg assembly:
(4) ¾" #10 Phillips screws
(1) Allen wrench
Allen wrench
Kalos Leg & Caster Assembly Instructions
Optional caster installation:
Skip to Step 3 if you are using glides.
Remove glides, using 9/ 1 6" wrench to loosen each nut
before unscrewing. Attach casters, screwing one into each
leg and tightening nut to secure.
Desk/Table with Casters
Table Height Leg Hole Number
243/ 4 " H
253/ 4 " H
263/ 4 " H
273/ 4 " H
283/ 4 " H
293/ 4 " H
303/ 4 " H
313/ 4 " H
323/ 4 " H
333/ 4 " H
343/ 4 " H
353/ 4 " H
363/ 4 " H
Mounting
plate
1
2
3
4
5
6
7
8
9
10
11
12
13
Ensure the plate is
fully seated in the
corner and secure
with a Phillips screw
demco.com 1