Demco Regency MTBP27 Instructions

You will need a Phillips Head Screw Driver and a Tape Measure to Assemble.

Hardware :

A: Screws(24)
A

Parts :

B: Legs(4)
B
STEP 1 (Square Table Top): Place Table Top(C) on a clean flat surface with desired table finish face down. Position
assembled legs as shown in Figure A.
Then, attach assembled Legs to Table Top using 6 Screws(A) per Leg.

IMPORTANT NOTICE:

• Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
• Check to be sure that you have all parts and hardware.
• Remove all wrapping materials, including staples & packing straps before you start to assemble.
• Keep all hardware parts and packaging out of reach of children.
·
MTBP27 Kee Post Table Legs INSTRUCTIONS
You will need 2 people for this assembly.
C: Table Top (may vary)
C
C
*NOTE: Place Legs at
least 1-inch away from
Edge Table*
Figure A