Advertisement
Quick Links
FRONTERA 2000 ON AIR BAG COMPATIBLE COMBINATION BAR
RODE0 / AMIGO 2000 ON (USA)
PRODUCT NUMBER
3448200
WHEN INSTALLED IN ACCORDANCE WITH THESE INSTRUCTIONS, THE FRONT
PROTECTION BAR DOES NOT AFFECT OPERATION OF THE SRS AIRBAG.
• THIS PRODUCT MUST BE INSTALLED EXACTLY AS PER THESE INSTRUCTIONS
USING ONLY THE HARDWARE SUPPLIED.
• IN THE EVENT OF DAMAGE TO ANY
NEAREST AUTHORISED ARB STOCKIST. REPAIRS OR MODIFICATIONS TO THE
IMPACT ABSORPTION SYSTEM MUST NOT BE ATTEMPED.
• DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL, OTHER THAN
THOSE SPECIFIED BY ARB.
• DO NOT REMOVE LABELS FROM THIS BULL BAR.
•
THIS PRODUCT OR ITS FIXING MUST NOT BE MODIFIED IN ANY WAY.
06-01-2005
WARNING
FOR VEHICLES EQUIPPED WITH SRS AIRBAG
TAKE NOTE OF THE FOLLOWING:
FITTING KIT NUMBER
6171398
BULL BAR
COMPONENT, CONTACT YOUR
Page 1 of 7
3782877
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ARB 3448200
Summary of Contents for ARB 3448200
- Page 1 • IN THE EVENT OF DAMAGE TO ANY BULL BAR COMPONENT, CONTACT YOUR NEAREST AUTHORISED ARB STOCKIST. REPAIRS OR MODIFICATIONS TO THE IMPACT ABSORPTION SYSTEM MUST NOT BE ATTEMPED. • DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL, OTHER THAN THOSE SPECIFIED BY ARB.
-
Page 2: Tools Required
WASHER FLAT M6 6151128 NUT FLANGE M6 3751313 NUMBER PLATE BRACKET BUFFERS AND TURN SIGNALS 3500170 BUFFERS KIT 3500080 ARB TURN SIGNALS 8-9000lb WINCH TO PAN 4581040 WASHER FLAT 3/8”x 1” 180302 CABLE TIES TOOLS REQUIRED 1 BASIC TOOL KIT, DRILL. - Page 3 ASSEMBLY SEQUENCE FOR BULL BAR INSTALLATION. 1. Remove bumper bar from the vehicle. 2. Fit the indicators into bar. 3. Fit numberplate bracket to bull bar using 6mm hardware if bar is going to have a winch fitted. 4. Fit buffers to bull bar using 6mm flange nuts supplied in buffer kit.
- Page 4 Remove the four solenoids from the base of the control box using the copper bus bar as an aid and hold to one side. Remove the two bolts in the base of the control box and reposition them into the more centralised holes.
- Page 5 10. Replace the 2 cap screws, washers and nuts removed in step 6 above into original holes. 11. Replace the black cover and refit the three cover screws (DO NOT OVER TIGHTEN) 12. Fit control box bracket to bull bar using 8mm hardware.
- Page 6 18. Fit control box to control box bracket and tighten firmly. 19. Pull wires through viewer cutout under control box and wire up as per Warn instruction manual. 20. Tie back cables clear of all moving parts with cable tie supplied. 21.
- Page 7 30. Connect the turn signal looms to the existing turn signal loom with the Scotchloks supplied. Test to ensure the turn signals function correctly. 31. Once bar is correctly fitted, undo front bolts in splash pan of vehicle, slide splash pan supplied between and refit bolts and finger tighten.
Need help?
Do you have a question about the 3448200 and is the answer not in the manual?
Questions and answers