HOMCOM 820-007 Assembly Instruction Manual page 7

Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be
switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons
more than once within two seconds for the fire to operate normally.
1. Boot steps
820-007:
1) Connect the power
2) Turn on the power switch
3) Press the "ON/OFF" key of the remote controller to start up
4) Press the 1000W button for the 1000W heat settings; press twice to switch off the
heat setting.
5) Press the 2000W button for the 2000W heat settings; press twice to switch off the
heat setting.
6) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise
and lower the brightness.
820-054:
1) Connect the power
2) Turn on the power switch
3) Press the "ON/OFF" key of the remote controller to start up
4) Press the 900W button for the 900W heat settings; press twice to switch off the
heat setting.
5) Press the 1800W button for the 1800W heat settings; press twice to switch off the
heat setting.
6) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise
and lower the brightness.
2. Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heating.
When turned on, the fireplace can automatically change the heating mode depending
on the set temperature and the room temperature.
During a timed starting process, it is possible to start heating ahead of schedule.
3. Setting the day and time
1) Settings are done on the remote controller
2) Press "DATE TIME" button, then press the "▲" or "▼" key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4) Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete
4. Temperature setting
The default set temperature is 20 ℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃. And this setting is only for the
temperature in the normally mode, not for the temperature in the timer mode.
NOTE: The set temperature must be higher than the room temperature for the heat
working.
7