Bison BLI0702 Assembly And Safe Use Manual

—— Assembly and Safe Use Manual ——
2 T
Models BLI0702, BLI1502 and BLI2102
P A R T S L I S T
Item 7 1/2' 15' 21'
Qty Qty Qty
A 3 6 6
B 0 0 3
C 2 3 4
D 11 17 23 3/8" x 1 1/4" Hex Bolt
E 6 9 12 3/8" Flat Washer
F 29 44 59 3/8" Hex Nut
G 29 44 59 3/8" Lock Washer
H 12 18 24 Bench Clamp
I 6 9 12 Rubber Foot
J 1 2 3
K 2 4 6
NOTE: Extra hardware may be included.
¨
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
¨
Read all instructions before proceeding.
While gym floor installers and refinishers often indicate floors are OK to walk or play on in 7-10 days after oil based polyurethane
finishes are applied, in reality, it can actually take up to 30 days for all the chemicals in the polyurethane to dissipate. Chemical
reactions between the floor finish and certain materials including urethane feet contacting the floor can cause permanent
discoloration. Placement of this product on floors prior to the 30-day final cure period may risk discoloration that would not be
1. Attach Rubber Feet (I) in 2 places to each Frame Assembly
(C) using 3/8" x 1 1/4" Hex Bolts (D), 3/8" Flat Washers (E),
3/8" Lock Washers (G) and 3/8" Hex Nuts (F). See Figure 1.
2. Position Frame Assemblies (C) approximately 72" apart on a
level flat surface. Install Front Brace (J) using 3/8" x 1 1/4"
Hex Bolts (D), 3/8" Lock Washers (G) and 3/8" Hex Nuts (F).
See Figure 2.
3. Using one each 3/8" x 1 1/4 " Hex Bolt (D), 3/8" Lock
Washers (G) and 3/8" Hex Nut (F) connect the two Rear
Braces (K) in the middle, leaving hardware finger tight.
See Figure 3.
Implementation Date: 10/23/24
I
IER NDOOR
Description
7 1/2' Plank
6' Plank
Welded Frame
Front Brace
Rear Brace
covered by the manufacturer's warranty.
Rev: 7 N.J.C.
B
LEACHER
Item 7 1/2' 15' 21'
Qty Qty Qty
L 2 3 4
M 12 18 24 3/8" x 1" Carriage Bolt
N 12 12 12 #10 x 3/4" Sheet Metal Screw
O 6 6 6
P 2 3 4
Q 4 6 8
R 0 6 12 Seat Connector Tube
S 0 3 6
T 0 24 48 #14 x 3/4" Self-Drilling/Threading Hex
U 0 1 1
Warning!
Figure 1
FileI:\Pub\Inst\BL Bench\BLEACHER
1
Customer Service
Description
Spacer
Seat End Cap
3/8" x 2 1/4" Hex Bolt
Swivel Caster
Seat Connector Cap
Screws
3/8" Hex Magne c Screwdriver Socket
Ref#: 990067
(800) 247-7668
L.M.