Hearth & Home MI25-3523 Installation Instructions

Surround / Front:
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
• CAREFULLY SUPERVISE children in same room as
fireplace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
flammable materials.
• Keep clothing, furniture, draperies and other flammable
materials away.
• Do NOT operate with protective barriers open or removed.
• The decorative front must remain closed if children will be
present during the operation of the fireplace.
• The decorative front may be made operable per these
instructions. This may be done only upon request of
a person responsible for the use and operation of the
fireplace.
• The decorative front can be returned to the locked position
following these instructions.
INTRODUCTION
The surround is used to fill the space between the insert
and the solid fuel firebox opening. The front is placed onto
the surround after it is attached to the insert. The surround
is required.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed under a surround.
Hearth & Home Technologies • Insert Surround / Front Installation Instructions • 2532-921 Rev. i • 5/24
TA-EXC25/30/35, INFIT-25/30/35 IA-MI25/30/35,
FS-MI25/30/35, MFV-EXC25/30/35, FA-EXC25/30/35,
HARC-MI25/30/35,CSFI25/30/35, CASFI25/30/35,
MFV-TRI35/30/35, FA-TRI25/30/35, TA-TRI25/30/35
Installation Instructions -
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
Combustible Materials Specification
Materials made of or surfaced with wood, compressed
paper, plant fibers, plastics, or other material that can ig-
nite and burn, whether flame proofed or not, or plastered
or unplastered shall be considered combustible materials.
SURROUND & FRONT INSTALLATION
1. Remove the shipping bracket from the surround. See
Figure 2.
2. Locate the coiled rocker switch wires and battery backup
on the insert. The wire assembly is zip-tied to the right side
of the appliance outer wrap.
3. Run both low voltage wires behind the surround. Connect
the low voltage wires to the rocker switch and USB-C plug..
See Figure 1.
Note: For alternative rocker switch location using the rocker
switch mounting bracket see Figure 2 for PROVIDENT/
JASPER metal inserts and see Figure 3 for all other
metal inserts.
4. Attach surround to the insert with four screws
(located in appliance manual bag). See Figure 4. When
installing a 4-sided surround, install shoulder screws
in bottom corners of surround opening. Bend tabs on
vanity panel toward the 90° return bend and hang on
shoulder screws. See Figures 5 and 6.
USB-C
PORT
ROCKER
SWITCH
SURROUND
Figure 1 Rocker Switch Detail
APPLIANCE
1