CommScope Ruckus T670sn Quick Setup Manual

T670sn Access Point
Quick Setup Guide
This Quick Setup Guide provides step-by-step instructions on how to field-
install the RUCKUS T670sn access point (AP). For detailed information on
planning the installation, performing a site survey, and operating the
T670sn, refer to the RUCKUS Outdoor Access Point User Guide, available at
https://support.ruckuswireless.com.
NOTE: The minimum software version for the T670sn AP is SmartZone
(SZ) 7.0 or later, Unleashed (UN) 200.17 or later, and RUCKUS One (R1)
7.0.0.200 or later.
WARNING! Installation of this equipment must comply with local and
national electrical codes.
WARNING! Only trained and qualified personnel should install, replace,
or service this equipment. This equipment should be installed in
restricted-access areas only.
WARNING! RUCKUS strongly recommends that you wear eye protection
before mounting the T670sn.
CAUTION! Make sure that you form an 80mm - 130mm (3 in. to 5 in.)
drip loop in any cable that is attached to the AP or the building. This will
prevent water from running along the cable and entering the AP or the
building where the cable terminates.
CAUTION! Be sure that grounding is available and that it meets local
and national electrical codes. For additional lightning protection, use
lightning rods and lightning arrestors.
CAUTION! Make sure that proper lightning surge protection
precautions are taken according to local electrical code.
This Guide in Other Languages
• 请从以下网站获得该指南的简体中文版
http://
docs.commscope.com/?docs-box.
• Vous trouverez la version française de ce guide à l'adresse suivante
http://docs.commscope.com/?docs-box.
• このガイドの日本語版は
http://docs.commscope.com/?docs-box
ご覧ください。
• 이 가이드의 한국어 버전은 웹 사이트
(http://docs.commscope.com/?
docs-box) 에서 확인하시기 바랍니다.
• Veja a versão em português (Brasil) deste guia em
docs.commscope.com/?docs-box
• Puede ver la versión en español (América Latina) de esta guía en
docs.commscope.com/?docs-box
Copyright © 2025 CommScope, Inc. All rights reserved.
Published April 2025, Part Number 800-73567-001 Rev A
Before You Begin
Before deploying RUCKUS products, please check for the latest software
and the release documentation.
• Release Notes and other user documentation are available at
support.ruckuswireless.com/documents.
• Software upgrades are available at
software.
• Software license and limited warranty information are available at
https://support.ruckuswireless.com/programs-warranty_registration.
Before deploying your RUCKUS Access Point and stadium mounting
enclosure, verify that all items listed in Package Contents are included in
the package. If any item is damaged or missing, notify your authorized
RUCKUS sales representative. Also, make sure that you have the required
hardware and tools.
Required Hardware and Tools
• ½-in. (13-mm) flat-blade screwdriver or equivalent
• No. 2 Phillips screwdriver
• Small flat-blade screwdriver
• Torque wrench or torque screwdriver with sockets
• Long-nose pliers
• Electrical wire stripping and terminal crimping pliers
• Pipe, pole, or a sturdy flat mounting surface
• Electric drill with drill bits and customer-supplied wall anchors, flat
washers, and hex nuts for flat-surface mount
Package Contents
A complete T670sn field installation package includes all of the items listed
below:
• T670sn Access Point
• M25 cable glands
• Outdoor AP Mounting Bracket kit
• One ground wire with lug
• Zip cord cable gland insert
• Four ½-in. (12.7-mm) wide adjustable clamps, 2.5-in. (63.5-mm)
diameter, for main mounting bracket on poles
• Safety cable kit
• Declaration of Conformity
で
http://
http://
T670sn AP Orientation
An introduction to the different views of the T670sn AP.
http://
FIGURE 1 T670sn AP Vent-side View
http://support.ruckuswireless.com/
• Protective vent to equalize pressure
FIGURE 2 T670sn AP Port-side View
1. Ground symbol
2. Ground screw
3. LED indicators
4. DC
WARNING! Do not use any PoE injector not tested and approved by
RUCKUS to power the T670sn Access Point. Only use a RUCKUS
qualified or approved PoE injector.
5. Ethernet
6. PoE IN
7. USB port
Page 1 of 7