Subscribe to Our Youtube Channel
Related Manuals for GreenWorks ST80B00
Summary of Contents for GreenWorks ST80B00
- Page 1 ST80B00/ ST80B210 STRING TRIMMER OPERATOR MANUAL STB301 www.greenworkstools.com...
-
Page 3: Table Of Contents
English Description......4 Stop the machine......10 Adjust the length of the Purpose...........4 cutting line........10 Overview......... 4 Line cut-off blade......10 Important safety Adjust the cutting diameter... 10 instructions......4 Operation tips....... 10 Symbols on the machine..5 Cutting tips........11 Risk levels...... -
Page 4: Description
English WARNING DESCRIPTION Read and understand all instructions before PURPOSE using this product. Failure to follow all instructions This machine is used to cut grass, light weeds, and listed below may result in electric shock, fire, and/or other similar vegetation at or around ground level. The serious personal injury. -
Page 5: Symbols On The Machine
fire. Use only with Greenworks GBA80250/ materials of other types – for example, metal wire, BAB723/ 2901302 battery or other BAB series. -
Page 6: Risk Levels
English Symbol Explanation SYM- SIGNAL MEANING Voltage WARNING Indicates a potential- Current ly hazardous situation, which, if not avoided, Frequency (cycles per second) could result in death or serious injury. Power CAUTION Indicates a potential- Time ly hazardous situation, Revolutions, strokes, surface speed, which, if not avoided, may /min orbits etc., per minute... -
Page 7: Proposition 65
English WARNING PROPOSITION 65 If the battery pack cracks or breaks, with or without WARNING leaks, do not recharge it and do not use. Discard it and replace with a new battery pack. DO NOT TRY This product contains a chemical TO REPAIR IT! To prevent injury and risk of fire, explosion, or electric shock, and to avoid damage to known to the state of California... -
Page 8: Attach The Edge Guide
English Remove the screws from the trimmer head with a WARNING Phillips head screwdriver (not included). Put the guard onto the trimmer head. • If parts of the machine are damaged, do not use the machine. • If you do not have all the parts, do not operate the machine. -
Page 9: Attach The Auxiliary Handle
English Push the battery pack into the battery NOTE compartment until the battery pack locks into place. The release button must be fixed in the positioning When you hear a click, the battery pack is hole. Using the wrong hole could lead to personal installed. -
Page 10: Stop The Machine
English STOP THE MACHINE Release the trigger to stop the machine. ADJUST THE LENGTH OF THE CUTTING LINE While you operate the machine, the cutting line gets worn and shorter. You can adjust the length of the cutting line. Hit the trimmer head against the ground while you operate the machine. -
Page 11: Cutting Tips
English CUTTING TIPS 10.2 CLEAN THE MACHINE • Tilt the machine toward the area to be cut. Use the • Clean the machine after each use with a moist cloth tip of the cutting line to cut grass. dipped in neutral detergent. •... -
Page 12: Install The Cutting Line
English Turn the spool cap counterclockwise to wind the cutting line into the trimmer head. Keep approximately 5 in of cutting line on each side of 10.4 INSTALL THE CUTTING LINE the trimmer head. NOTE Do not put more than 13 feet of cutting line in at a time. -
Page 13: Transportation And Storage
English Problem Possible Solution Cause The lock-out 1. Pull the lock-out button and trig- button and hold it. ger are not pushed at the 2. Pull the trigger to same time. start the machine. The ma- The guard is Remove the battery chine not attached to pack and attach the... -
Page 14: Technical Data
English Problem Possible Solution Weight (without battery 7.5 lbs (3.4 kg) Cause pack) The line Lines are wel- Lubricate with silicone Battery model GBA80250/BAB723/ does not ded to them- spray. 2901302 and other BAB extend. selves. series Not enough line Install more line. - Page 15 It is the purchaser’s responsibility to pay transportation charges for any part submitted for replacement under this warranty unless such return is requested in writing by Greenworks. USA address: Greenworks Tools P.O. Box 1238, Mooresville, NC 28115 Canadian address: Greenworks Tools Canada, Inc.
-
Page 16: Replacement Parts
English REPLACEMENT PARTS Part No. Description Part No. Description R0200097-00 Auxiliary handle assembly R0201885-00 Edge guide R0202682-00 Trimmer head assembly R0201886-00 Hex Screw R0202683-00 Guard assembly R0201770-00 Allen key... - Page 17 www.greenworkstools.com Rev B1...
Need help?
Do you have a question about the ST80B00 and is the answer not in the manual?
Questions and answers