Download Print this page
Assa Abloy Norton Rixson UNI-J7500 DA Series Installation Instructions
Assa Abloy Norton Rixson UNI-J7500 DA Series Installation Instructions

Assa Abloy Norton Rixson UNI-J7500 DA Series Installation Instructions

Non hold open or hold open, top jamb unitrol door closer

Advertisement

Quick Links

UNI-J7500 (DA) (H) Series
®
Unitrol Door Closer
Non Hold Open or Hold Open, Top Jamb
Installation Instructions
WARNING
This product can expose you to lead which is known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65warnings.ca.gov.
Components
Screw Pack
Optional Accessories
Thru-Bolt
&
Grommet Nuts
Ÿ
Always use template covering door opening angle desired,
correct door thickness and frame reveal, and door hanging
hardware being used. Template dimensions in these instructions
(page 2) cover frame reveals to 7-3/8" (187mm) in openings with
1-3/4" (44mm) thick doors hung on 4-1/2" (114mm) wide
template hinges (Figure 3), 3/4" (19mm) offset pivots (Figure 3)
or center pivots (Figure 4).
Ÿ
Check hand of door: right or left (see Figure 6, page 3). Make
sure that door opens the full angle desired and latches without
any binding action or interference. Note that hold open units will
require that door swing five (5) degrees past hold open point to
dead stop position.
Copyright © 2008, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9377-1401-020 Rev 3 03/22
Tube
Closer
Assembly
7786 Backplate
4 Plate Screws
Power
Adjustment Nut
Cover Options
Plastic Cover (Standard)
2 Cover Screws
Ÿ
Always use sex nuts and bolts to mount arm foot and to mount
closer plate in flush partitions.
Ÿ
Top Jamb Unitrols are supplied with arm rod UNI-E according to
frame reveal. An arm number is stamped on these arm rods as
shown on Figures 3 and 4 (page 2).
NORTON
RIXSON
An incorrectly installed or improperly
adjusted door closer can cause
property damage or personal injury.
These instructions should be
followed to avoid the possibility of
misapplication or misadjustment.
2 Sleeve-nuts
(Arm Number Stamp)
Main Arm
Screw
Rod Screws
Slide unit
Holder Control
Metal Cover (Optional)
Rod Unit
2 Cover Screws

Advertisement

loading
Need help?

Need help?

Do you have a question about the Norton Rixson UNI-J7500 DA Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Assa Abloy Norton Rixson UNI-J7500 DA Series

  • Page 1 Copyright © 2008, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
  • Page 2 Figure 4 Copyright © 2008, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
  • Page 3 Figure 6 Copyright © 2008, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
  • Page 4 Techsupport.NortonRixson@assaabloy.com NortonRixson.com Copyright © 2008, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole 80-9377-1401-020 Rev 3 03/22 or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.

This manual is also suitable for:

Norton rixson uni-j7500 h series