Assa Abloy NORTON RIXSON Unitrol UNI-7500 (DA) (H) Series Installation Instructions

UNI-7500 (DA) (H) Series
®
Unitrol Door Closer
Non Hold Open or Hold Open, Parallel Arm
Installation Instructions
WARNING
This product can expose you to lead which is known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65warnings.ca.gov.
Components
Closer
Assembly
Screw Pack
Optional
6191 Reinforcing Kit
for Deep Reveal
2019L Bracket
for Flush Partition
4 bracket
screws
Use these instructions for installing all models of these
Ÿ
series on 1-3/4" (45mm) doors hung on 4-1/2" (114mm)
wide hinges or 3/4" (19mm) offset pivots.
DOOR WIDTH determines the location of the closer. Use
Ÿ
ONLY the template chart corresponding to your door width.
Ÿ Use ONLY the dimensions given in each template chart for
the door total OPENING angle or the HOLD-OPEN angle
desired.
®
Unitrol parallel arms are supplied in one of three lengths,
Ÿ
according to door width specified on order. To verify that
the ARM you have is CORRECT FOR THE DOOR WIDTH,
check the number stamped on the arm against the chart.
Copyright © 2007, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9377-1351-020 Rev 3 03/22
6190 Bracket
Tube
Power
Adjustment Nut
Thru-Bolt
&
Grommet Nuts
7786 Backplate
4 Plate Screws
Cover Options
Plastic Cover (Standard)
2 Cover Screws
DOOR
Non-Holder Arm
WIDTH
28"-32"
6100-11
0.70-0.80M
33"-41"
6100-13
0.85-1.00M
42"-48"
6100-14
1.05-1.20M
NORTON
RIXSON
An incorrectly installed or improperly
adjusted door closer can cause
property damage or personal injury.
These instructions should be
followed to avoid the possibility of
misapplication or misadjustment.
®
Unitrol Parallel Arm
Assembly
Metal Cover (Optional)
2 Cover Screws
Hold-Open Arm
6100-1
6100-3
6100-4