Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FOR-A HVS-DNT
Summary of Contents for FOR-A HVS-DNT
- Page 1 INSTALLATION GUIDE HVS-DNT Dante I/F Card Edition...
-
Page 2: Upon Receipt
Installation guide (This guide) The HVS-DNT cards are inserted from the rear of the main unit. The installation of expansion cards should only be done by qualified technical personnel. To protect the card from electrostatic damage, do not touch the components on the card. -
Page 3: Table Of Contents
Table of Contents 1. Installing onto HVS-490 ........................4 1-1. Card Installation Slot ........................4 1-2. Inserting a Card into a Slot ......................4 1-3. Checking the Installation ......................4 2. HVS-490 Input / Output Settings ......................5 2-1. Input Channel ..........................5 2-2. Output Channel ...........................5 3. -
Page 4: Installing Onto Hvs-490
(4) Make sure that the card is inserted correctly and tighten both screws on the rear panel. (5) Connect the power cord and turn on the power of the switcher. 1-3. Checking the Installation Open the [STATUS > OPTION] menu to see that the HVS-DNT card you have installed into the slot is properly recognized. -
Page 5: Hvs-490 Input / Output Settings
2-2. Output Channel The HVS-DNT card can output up to 64 channels of Dante audio and up to 2 SDI (with 16 channels of audio) signals. It can also pass two sets of 16-ch audio to the switcher to replace embedded audio channels of SDI outputs using ANC data replacement procedure. -
Page 6: Installing Onto Hvs-190S
(5) Connect the power cord and turn on the power of the switcher. 3-3. Checking the Installation Open the [SETUP > STATUS > OPTION] menu to see that the HVS-DNT card you have installed into the slot is properly recognized. -
Page 7: Hvs-190S Input / Output Settings
4-2. Output Channel The HVS-DNT card can output up to 64 channels of Dante audio and up to 2 SDI (with 16 channels of audio) signals. It can also pass two sets of 16-ch audio to the switcher to replace embedded audio channels of PGM, PVW, CLN or AUX outputs using ANC data replacement procedure. -
Page 8: Installing Onto Hvs-190I
(5) Connect the power cord and turn on the power of the switcher. 5-3. Checking the Installation Open the [SETUP > STATUS > OPTION] menu to see that the HVS-DNT card you have installed into the slot is properly recognized. -
Page 9: Hvs-190I Input / Output Settings
6-2. Output Channel The HVS-DNT card can output up to 64 channels of Dante audio and up to 2 SDI (with 16 channels of audio) signals. It can also pass two sets of 16-ch audio to the switcher to replace embedded audio channels of PGM, PVW, CLN or AUX outputs using ANC data replacement procedure.
Need help?
Do you have a question about the HVS-DNT and is the answer not in the manual?
Questions and answers