Moving Memory Data To; The Main Band (Vfo-A); Memory Tune Operation - Yaesu FT-2000 Operating Manual

M O
EMORY
Moving Memory Data to the Main Band VFO-A
You may transfer the contents of the currently-selected memory channel into the Main band (VFO-A) register, if you like.
1. Press the [ V/M ] button, as necessary, to go to the
Memory mode. The memory channel number will ap-
pear in the multi-panel window.
2. Press the [ M CH ] button. The Red LED inside the
switch will light up, indicating that you are ready to
recall a memory channel.
A :
If the Red LED imbedded in the [ M CH ] button does
not light up, check to be sure that the orange lamp to
the right of the [ SUB VFO-B ] knob is not illuminated.
If it is, press the [ A/B ] switch to make it go out, then
press the [ M CH ] button again.
3. Rotate the [ SUB VFO-B ] knob to select the memory
channel the contents of which you wish to transfer to

the Main band (VFO-A).

4. Press and hold in the [ A M ] button for two seconds,
until you hear the double beep. The data in the selected
memory channel will now be transferred to the Main
band (VFO-A).
A :
This transfer of data to the Main band (VFO-A) does not
affect the original contents of the memory channel; this is
a "copy" function that leaves the memory contents un-
changed.

Memory Tune Operation

You may freely tune off of any memory channel in a "Memory Tune" mode that is similar to VFO operation. So long as
you do not over-write the contents of the current memory, Memory Tune operation will not alter the contents of the
memory channel.
1. Press the [ V/M ] button to recall any memory channel.
2. Rotate the Main Tuning Dial knob; you will now ob-
serve that the memory channel's frequency is chang-
ing.
A :
The " " icon will replace the "
multi-panel window, indicating you are in the
"Memory Tune" mode.
During Memory Tune operation, you may change
operating modes, and engage the Clarifier, if de-
sired.
3. Press the [ V/M ] button momentarily to return to the
originally-memorized frequency of the current memory
channel. One more press of the [ V/M ] button will re-
turn you to VFO operation.
Page 102
PERATION
S M
TANDARD EMORY
" icon in the
O
PERATION
Main Tuning Dial Knob
N :
Computer software programs utilizing the CAT system
interface port may presume that the transceiver is operat-
ing in the VFO mode for certain features like "band map-
ping" and/or frequency logging. Because the "Memory
Tune" mode so closely resembles the VFO mode, be sure
that you have the FT-2000D operating in a control mode
compatible with your software's requirements. Use the
VFO mode if you're not sure.
FT-2000D O
[ V/M ] Button
[ SUB VFO-B ] Knob
[ A M ] Button [ M CH ] Button
[ V/M ] Button
M