Table of Contents
Advertisement
M
EMORY
10. If you make a mistake, press the B key to backspace the cursor, then re-enter the
correct letter, number, or symbol.
11. When you have completed the changes of the label, press the PTT switch to save the
label and exit.
Data stored on memory channels can easily be moved to VFO, if you like.
1. Press the c key, if needed, to enter the Memory Recall ("MR") mode.
2. Press and hold in the f key for 1/2 second, then rotate
the DIAL knob to select the memory channel containing the
frequency data to be moved to VFO.
3. Press the c key. The confirmation message (OVER-
WRITE?) will appear on the display. Press the c key once
more, the data will now have been copied to VFO, although
the original memory contents will remain intact on the pre-
viously stored channel. Press the PTT switch to cancel the
Moving Memory Data procedure, if desired.
If a Split Frequency Memory channel was transferred, the Tx frequency will be
ignored (you will be set up for Simplex operation on the Receive frequency).
Once memory channel programming has been completed, you may place the radio in a
"Memory Only" mode, whereby VFO operation is impossible. This may be particularly
useful during public-service events where a number of operators may be using the radio
for the first time, and ultimate simplicity of channel selection is desired.
To place the radio into the Memory Only mode, turn the radio off. Now press and hold in
the c key while turning the radio on.
To return to normal operation, repeat the above power-on procedure.
VX-8GR/GE O
PERATING
M
ODE R
EGULAR
M
EMORY
M
M
OVING
EMORY
M
EMORY
M
ANUAL
M
EMORY
B
O
ANK
PERATION
D
ATA TO THE
O
M
NLY
ODE
C
O
HANNEL
PERATION
VFO
51
Advertisement
Table of Contents
