Moving Memory Data To The Vfo-A; Memory Tune Operation - Yaesu FTdx5000MP Operating Manual

M O
EMORY

Moving Memory Data to the VFO-A

You may transfer the contents of the currently selected memory channel into the Main band (VFO-A) register, if you like.
1. Press the [ V/M ] button briefly, as necessary, to enter
the Memory mode. The memory channel number will
appear in the small window at the lower right corner of
the display.
2. Press and hold the [ BAND/MCH ] button for two sec-
ond. The [ BAND/MCH ] button will glow yellow, in-
dicating that you are ready to select a memory channel
using the [ CLAR ( VFO-B )] knob.
3. Rotate the [ CLAR ( VFO-B )] knob to select the memory
channel you wish to transfer to VFO-A.
4. Press and hold in the [ M A ] button for two seconds,
until you hear the double beep. The data in the selected
memory channel will now be transferred to the VFO-
A.
A :
The transfer of data to the VFO-A does not affect the origi-
nal contents of the memory channel. This is a "copy" func-
tion that leaves the memory contents unchanged.

Memory Tune Operation

You may freely tune the frequency off of any memory channel in a "Memory Tune" mode. This is similar to VFO operation.
So long as you do not over-write the contents of the current memory, Memory Tune operation will not alter the contents of
the memory channel.
1. Press the [ V/M ] button briefly, to recall any memory
channel.
2. Rotate the Main Tuning Dial knob and you will see
that the memory channel frequency is changing.
A :
The " " icon will replace the "
the small window at the lower right corner of the
display, indicating you are in the "Memory Tune"
mode.
During Memory Tune operation, you may change
operating modes, and engage the Clarifier, if de-
sired.
3. Press the [ V/M ] button briefly to return to the origi-
nally-memorized frequency of the current memory
channel. One more brief press of the [ V/M ] button will
return you to VFO operation.
N :
Computer software programs utilizing the CAT system
interface port may presume that the transceiver is operat-
ing in the VFO mode for certain features like "band map-
ping" and/or frequency logging. Because the "Memory
Tune" mode so closely resembles the VFO mode, be sure
that you have the FT 5000 operating in a control mode
DX
compatible with your software requirements. Use the VFO
mode if you're not sure.
Page 104
PERATION
R M
EGULAR EMORY
" icon in
O
PERATION
Main Tuning Dial Knob
FT 5000 O
DX
[ V/M ] Button
[ BAND/MCH ] Button
[ M A ] Button
[ CLAR ( VFO-B )] Knob
[ V/M ] Button
M
PERATING ANUAL