MSI 865GM2-LS - Motherboard - Micro ATX User Manual page 67

MS-6743 M-ATX Mainboard
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
ECP + EPP: Extended Capability Port + Enhanced Parallel Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port
only, choose "SPP." To operate the onboard parallel port in the
EPP mode simultaneously, choose "EPP." By choosing "ECP",
the onboard parallel port will operate in ECP mode only. Choos-
ing "ECP + EPP" will allow the onboard parallel port to support
both the ECP and EPP modes simultaneously.
EPP Mode Select
The onboard parallel port is EPP Spec. compliant, so after the user chooses
the onboard parallel port with the EPP function, the following message
will be displayed on the screen: "EPP Mode Select." At this time either
EPP 1.7 spec or EPP 1.9 spec can be chosen.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard
parallel port with the ECP feature. After selecting it, the following mes-
sage will appear: "ECP Mode Use DMA." At this time, the user can
choose between DMA channel 3 or 1.
PWRON After PWR-fail
This item specifies whether your system will reboot after a power failure
or interrupt occurs. Available settings are:
Off
On
Former-sts
3-22
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the status before power failure or
interrupt occurred.