Cabinet Safety Precautions - HP A4500A - VMEbus Single Board Computer 744 Motherboard Safety And Regulatory Information Manual

Cabinet Safety Precautions

WARNING Cabinets are heavy even when empty. Exercise caution when moving cabinets
whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough
or uneven surfaces or inclines greater than 10 degrees. Unloading cabinets from the
pallet and movement of cabinets should be performed by at least two people.
WARNING Slideable products are not to be extended from the cabinet while the equipment is
on the shipping pallet. The cabinet must be unloaded from the pallet and both front
and rear anti-tip feet properly installed prior to extending any slideable product.
WARNING Once installed, both the front and rear anti-tip feet must remain in place to maintain
stability. Only one slideable product must be extended at a time.
WARNING Use of any slide mount product requires the installation of a cabinet anti-tip device.
The anti-tip device for the following cabinet products is a pair of anti-tip feet:
A4900A, A4901A, A4902A, A5134A, A5135A, A5136A, J1500A, J1501A, and J1502A.
Install both front and rear anti-tip feet on the cabinet before installing any slide
mount product.
The anti-tip device for the following cabinets is the installation of ballast in the
bottom of the cabinet: A1896A, A1897A, A1883A, A1884A, C2785A, C2786A, and
C2787A.
To determine ballast requirements, refer to the ballast worksheets in documentation
accompanying the cabinet or http://www.hp.com/enclosures/c_rocs.htm
Failure to follow these precautions can result in damage to equipment or injury to
personnel
Chapter
hp Server rp24xx Safety and Regulatory Information
9