Laser Safety; Cabinet Safety Precautions - HP Rp3440-4 - 9000 - 0 MB RAM Safety And Regulatory Information Manual

HP 9000 rp3410 and HP 9000 rp3440 System Safety and Regulatory Information
Overview

Laser Safety

NOTE Laser devices installed in this equipment must be certified as Class 1 Laser devices by the
Regulatory Agency recognized by the country where the equipment is installed.
If a Fibre Channel I/O card is present, the following laser safety statement applies.
NOTE
This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre
communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
NOTE If a DVD is present, the following laser safety statement applies.
This product contains a laser internal to the Digital Versatile Disc (DVD) housing.
In the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the DVD housing.
Outside the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993+A1 and EN 60825-1:1994+A11.

Cabinet Safety Precautions

Cabinets are heavy even when empty. Exercise caution when moving cabinets
WARNING
whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough
or uneven surfaces or inclines greater than 10 degrees. Unloading cabinets from the
pallet and movement of cabinets should be performed by at least two people.
Slideable products are not to be extended from the cabinet while the equipment is
on the shipping pallet. The cabinet must be unloaded from the pallet and all anti-tip
devices properly installed prior to extending any slideable product.
Once installed, all anti-tip devices must remain in place to maintain stability. Only
one slideable product must be extended at a time.
To determine ballast requirements, refer to the ballast worksheets in documentation
accompanying the cabinet, or to information available at http://docs.hp.com.
Failure to follow these precautions can result in damage to equipment or injury to
personnel.
English 6
Chapter 1