Laser Safety; Cabinet Safety Precautions - HP Integrity rx2800 - i2 Safety And Regulatory Information Manual

Lithium Battery Caution (for User Replaceable Batteries)
WARNING!
of explosion if battery is installed incorrectly.
Replace only with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer's instructions and local disposal requirements.
IMPORTANT:

Laser Safety

NOTE: Laser devices installed in this equipment must be certified as Class 1 Laser devices by
the Regulatory Agency recognized by the country where the equipment is installed.
NOTE:
If a Fibre Channel I/O card is present, the following laser safety statement applies.
This product contains a laser internal to the Optical Link Module (OLM) for connection to the
Fibre communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements
contained in the Department of Health and Human Services (DHHS) regulation 21 CFR,
Subchapter J. The certification is indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements
contained in IEC 60825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
NOTE:
If a DVD is present, the following laser safety statement applies.
This product contains a laser internal to the Digital Versatile Disc (DVD) housing.
In the USA, the DVD is certified as a Class 1 laser product conforming to the requirements
contained in the Department of Health and Human Services (DHHS) regulation 21 CFR,
Subchapter J. The certification is indicated by a label on the DVD housing.
Outside the USA, the DVD is certified as a Class 1 laser product conforming to the requirements
contained in IEC 60825-1:1993+A1 and EN 60825-1:1994+A11.

Cabinet Safety Precautions

WARNING!
whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough or uneven
surfaces or inclines greater than 10 degrees. Unloading cabinets from the pallet and movement
of cabinets should be performed by at least two people.
Slideable products are not to be extended from the cabinet while the equipment is on the shipping
pallet. The cabinet must be unloaded from the pallet and all anti-tip devices properly installed
prior to extending any slideable product.
Once installed, all anti-tip devices must remain in place to maintain stability. Only one slideable
product must be extended at a time.
To determine ballast requirements, refer to the ballast worksheets in documentation accompanying
the cabinet, or to information available at
Failure to follow these precautions can result in damage to equipment or injury to personnel.
Observe the correct polarity when changing the lithium battery. There is a danger
Switzerland: Annex 4.10 of SR 814.013 applies to batteries.
Cabinets are heavy even when empty. Exercise caution when moving cabinets
http://www.hp.com/go/racksolutions
.
Overview 5